The following page gives you the basic 'step-by-step' instructions for installing our clip-rail system in your gallery, office etc., including 'hints & tips' for making the installation process even easier than it already is.

clip-rail
installation guide

(1)With a pencil, draw a horizontal line along the wall where you need the rail.

(2) Drill holes at approx. 25cm intervals along that pencil line and insert wall plugs.
Tip:Hardwalls-use 6 mm drill bit and medium size (red) hard wall plugs.
Plaster walls-use 6 mm drill bit and plaster plug.

(3) Screw in mounting-clips and cut lengths of rail to fit.

(4) If you are using perlon cord with disc or barrel anchors: cut a notch 1cm approx. out of the back of the rail at desired intervals, so able to slide in/out anchors. (Refer to fig.1) note: Not necessary if using cobra anchors.

(5) Attach end-pieces, corner-connectors and straight-connectors where appropriate.

(6) Clip on rail.
Tip: Firstly hang the rail over the mounting-clips at the top. Then clip on the rail pressing firmly near the bottom. (Refer to fig.2).
If for any reason you need to un-clip the rail and put it up again, give the mounting-clips a quater turn so that you are clipping over a new bit.